The following Eagle .brd files can be sent to OSHPark. The Zipped gerber files can be sent directly to PJRC for fabrication

Keyboard_Scanner.brd EagleCad circuit board file for Teensy LC or 3.2. Original layout shown in the video. Use the LT2 board instead.

Keyboard_Scanner_LT.brd EagleCad file same as above with 2 bit Level Translator for touchpad Clock and Data on Teensy LC side. Use the LT2 board instead.

Keyboard_Scanner_LT2.brd EagleCad file same as above with improved hole spacing for using right angle header on Teensy 3.2 backside signals

Keyboard_Scanner_LT_0p5.brd EagleCad file same as above except made for a 0.5mm pitch FPC connector

Keyboard_Scanner_Dual.brd EagleCad file is for keyboards with dual FPC cables

Keyboard_Scanner_4p0.brd EagleCad file for Teensy LC or 4.0 with 1mm or 0.8mm pitch

Keyboard_Scanner_4p0_0p5.brd EagleCad file for Teensy LC or 4.0 with 1mm or 0.5mm pitch

Keyboard_Scanner_LC_thruhole.brd EagleCad file for thru-hole 1mm pitch FPC cables with up to 26 pins.

TeensyLC_1p25.brd EagleCad file for thru-hole 1.25mm pitch FPC cables with up to 26 pins.

Keyboard_Scanner_2pp.brd EagleCad file for Teensy ++2.0

FPC_8pin1mm.brd EagleCad file for 8 pin 1mm breakout board

FPC_10pin0p5mm.brd  EagleCad file for 10 pin 0.5mm breakout board

FPC_18pin1mm.brd  EagleCad file for 18 pin 1mm, 0.8mm, or 0.5mm breakout board

Teensy3p2Cutout.brd EagleCad file has a cutout in the board so the Teensy 3.2 will sit flush instead of on top of the board. 

Teensy3p2CutoutFlip.brd EagleCad file is the same as above file but it has the cutout on the right side instead of the left side.

iBookG3Cutout.brd EagleCad file is the same as above but with a 40 pin connector specifically for the iBookG3 keyboard.